Arlo Go 2 - Optimizing Mobile Signal Strength

12Get Started
Arlo Go 2 LTE/WiFi Security Camera
User Manual
LED behavior aer setup
• Solid blue: The LED lights solid blue when the camera is powered on and then turns o to
conserve battery power.
• Fast blinking blue: The camera’s charging cable is plugged in to a power adapter or the
camera is connected to the optional Arlo Solar Panel VMA5600 (sold separately).
• Single blink or double blink amber every 60 seconds: The battery charge is low. A single
blink every 60 seconds indicates a low battery charge. A double blink indicates a critical
battery charge level.
• Alternating blue and amber: A rmware update is in progress.
• Single blink amber, followed by restart: The camera has been factory reset. For more
information, see Reset using the sync button on page 71.
Check your Go 2 Camera’s mobile signal
strength
1. Open the Arlo app.
2. Tap Settings > My Devices.
3. Select your camera.
4. Tap Connected To > Cellular Settings > Signal Strength.
If signal strength is consistently less than three bars, consider moving your camera to a
location with better signal strength.
Optimize mobile broadband connectivity for
your Go 2 Camera
• Check your service provider’s data coverage map for the area in which you want to use
your camera.
Note: Cellular coverage, including LTE coverage, uctuates based on network traic
and weather conditions. If you place your camera near the edge of a coverage area, your
connection weakens or drops whenever the mobile network is carrying a lot of traic in
that area. Heavy rain, thunderstorms, and high humidity can also weaken your mobile
broadband connection.
• Check the mobile network signal strength in the location where you want to use your
camera aer setup.