61
ASSA ABLOY Hospitality
66 8003 016-3
To initialize the master thermostat with suite settings
1. Choose Initialize in the left pane of the
Orion Service window.
2. In this example, the master thermostat
is in room 102 (room A in Figure C10
).
Connect the service cable to the
thermostat in room 102.
3. Click the plus sign for the applicable
door area(in this example 'Floor 1') and
mark room 102.
Figure C13
4. At Suite settings:
- Enter the Suite room (slave room);
in this example 103 (room B in Figure
C10).
- Leave the Share occupancy
checkbox empty; this is only
applicable when there is just one door
to the entire suite;
click here
for more information about
that confi
uration.
Figure C14
5. Click the Initialize button.
Note:
It is only the master room that
is initialized with suite settings, so
steps 1-4 above are never performed
for the slave room.
Figure C15
Online network tree
When steps 1-4 below have been performed, the Online Network tree in SysMon
will typically look as in the example in Figure C16:
1. The thermostats have been initialized
with "regular parameters", i.e. all
parameters except for those related to
suite.
2. Thermostats, motion sensors and guest
room locks have been connected to the
online network according to chapter 5
.
3. The master room thermostat has been
initialized with suite settings according
to here
.
4. The status of the master room
thermostat and of the slave room
thermostat has been read out according
to here
.
Figure C16
To Next Page
Loading...
Need help?
General