To Next Page

To Previous Page

Rubber Track Loader

6. Chassis Disassembly and Assembly

6-4

Note: Make sure that the wire on the sending unit is not

bent and the fuel pickup line does not interfere with the

movement of the float.

3. Connect the hoses and wires to the fuel-sending

unit, and then install the screws that fasten the

unit to the tank.

Note: Be careful not to cross the wires or hoses. If the

fuel sending unit wires are crossed, the fuel gauge will not

work. If the hoses are crossed, the engine will not run.

4. Install the seat. Refer to Chapter 6. Seat Instal-

lation procedure.

https://tractormanualz.com/

Other manuals for ASV RC-50

Questions and Answers:

Need help?

Do you have a question about the ASV RC-50 and is the answer not in the manual?

General