Rubber Track Loader
8. Hydraulic Reservoir Disassembly and Assembly
8-6
Hydraulic Reservoir Cleaning
Procedures
Cleaning procedures are provided for the following
hydraulic reservoir components.
• Hydraulic Reservoir
Hydraulic Reservoir Cleaning
The tools required for hydraulic reservoir cleaning
are listed in Table 8-5. Use manufacturer-
recommended tools whenever possible.
Table 8-5
Tool Name
Combination Wrench
! WARNING !
Hot oil can cause personal injury. Make sure the oil is
cool before removing any components or lines.
Remove the oil filler cap only when the engine is
stopped and the filler cap is cool enough to touch with
your bare hand.
NOTICE
Collect and contain liquids in a suitable container. Dispose
of all liquids according to local regulations and mandates.
1. Drain the hydraulic fluid. Refer to Chapter 16.
Hydraulic Fluid and Filter Change.
2. Remove the access cover assembly. Refer to
Chapter 8. Access Cover Assembly Removal.
3. Thoroughly wipe out the interior of the hydraulic
reservoir with a magnet and a clean rag.
4. Install the access cover assembly. Refer to
Chapter 8. Access Cover Assembly Installation.
5. Add manufacturer-approved hydraulic fluid.
https://tractormanualz.com/
To Next Page
Loading...
Need help?
General
