Rubber Track Loader
11. Undercarriage Disassembly and Assembly
11-7
Figure 12-20
3. Remove the snap ring that secures the bearing
pack unto the shaft. (Photo shows the bearing
pack already removed.)
Figure 0-19A 12-023
4. Remove the three bolts on the bottom that
fastens the bearing plate to the drive table.
5. Using two pry bars, slowly and carefully pry the
bearing plate off of the shaft.
Figure 0-20 12-024
6. Remove the 4 bolts that fasten the bearing pack
to the bearing plate.
Sprocket Removal and
Installation
The tools required for sprocket removal and
installation are listed in Table 0-5. Use
manufacturer-recommended tools whenever
possible.
Table 0-5
Required Tools
Socket Wrench Torque Wrench
Sprocket Removal
Remove Snap Ring
https://tractormanualz.com/
To Next Page
Loading...
Need help?
General
