Rubber Track Loader
10. Transmission and Drive Disassembly and Assembly
10-2
Remove the oil filler cap only when the engine is
stopped and the filler cap is cool enough to touch
with your hands.
NOTICE
Collect and contain liquids in a suitable container. Dispose
of all liquids according to local regulations and mandates.
Note: During disassembly, cap all hoses and fittings to
prevent fluid loss and contamination of the system fluids.
1. Lower the lift arms to the ground.
2. Turn the engine start switch to the OFF position.
3. Relieve hydraulic pressure from the auxiliary
circuit.
4. Drain the hydraulic fluid. Refer to Chapter 16.
Hydraulic Fluid and Filter Change.
5. Remove the seat. Refer to Chapter 6. Seat Re-
moval.
Figure 10-1 10-001
6. View with seat removed.
Figure 10-2 10-002
7. Remove the access cover beneath the seat.
Figure 10-3 10-003
8. Disconnect the 4-bolt split flange fitting.
Figure 10-4 10-004
Remove
Split
https://tractormanualz.com/
To Next Page
Loading...
Need help?
General
