148
Answering system
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. The tone stops when all
new messages have been reviewed. By default, the message alert tone is O.
To turn on or o the message alert tone:
1. Press MENU in idle mode.
2. Press CID or DIR to highlight Answering sys, then
press SELECT .
3. Press CID or DIR to highlight Ans sys setup, then
press SELECT .
4. Press CID or DIR to highlight Msg alert tone, then
press SELECT .
5. Press CID or DIR
to choose On or O, then press SELECT.
Notes:
f To temporarily turn o the message alert tone, see page 153.
f The message alert tone beeps only if all the following conditions are met.
– Answering system is on.
– Message alert tone setting is on.
– There are new messages.
ANSWERING SYS
# of rings
Remote code
Msg alert tone
BACK SELECT
MSG ALERT TONE
On
Off
BACK SELECT
ANS SYS SETUP
# of rings
Remote code
Msg alert tone
BACK
SELECT
MSG ALERT TONE
On
Off
BACK
SELECT
To Next Page
Loading...
Need help?
General
