26
Bluetooth
Bluetooth setup
The screen displays Adding Headset Y when the base is
connecting to your headset (Headset Y represents the
device name of your Bluetooth headset).
When a device is successfully connected, the telephone base
displays Headset Y is added and connected to base. and
the corresponding status icon 2 (Headset Y represents
the device name of your Bluetooth headset). You hear a
CELL 2/HEADSET light on the
telephone base turns on.
If you have trouble pairing your headset, it may not be compatible
with your TL96457/TL96547. Check the Bluetooth compatibility list at
telephones.att.com/bluetooth.
Notes:
f The pairing process may take up to one minute. If the pairing process fails, try again.
f When a connected headset is charging, it may disconnect from the telephone base and the CELL 2/HEADSET
light on the telephone base turns o. For some headset models, you may need to turn on the headset and reconnect
it to the telephone base again.
Auto connection
When an active device moves within Bluetooth range of the telephone base,
or is turned on within range, the telephone base tries to connect to the device.
When the device moves out of range, it is disconnected. Your device might
make a connect or disconnect sound.
A connected device could also be disconnected by:
f
f
f Disconnecting through the telephone base Device list. If you disconnect
through the Device list, the telephone base will not attempt to reconnect
until your device is moved out of range and then moves back in range again.
Bluetooth connection from idle mode
When you have active devices that are not connected, CONNECT appears on
idle handsets and telephone base. Press CONNECT to start connecting an
active device. When there are two active devices, the handset will prompt you
to choose one before connection.
Adding
Headset Y
Headset Y
is added
and connected
to base.
To Next Page
Loading...
Need help?
General
