33
Bluetooth
Bluetooth setup
Change PIN
You are required to enter a PIN when establishing a Bluetooth connection. The
default PIN of your telephone base is 0000.
To change the PIN:
1. Press MENU on the telephone base in idle mode.
2. Press CID or DIR to highlight Bluetooth, then
press SELECT.
3. Press CID or DIR to highlight Change PIN, then press
SELECT. The screen displays ENTER NEW PIN and the
existing PIN.
4. Use the dialing keys to enter a new 4-digit code.
f Press CID or DIR to move the cursor to the right
f Press X/DELETE to erase a digit.
f Press and hold X/DELETE to erase all digits.
5. Press SET
Cell ringer
If this feature is on and you have connected an iPhone device (iOS 4.1 or later)
to your telephone system, the telephone plays your iPhone ringtone when
there is an incoming call.
To turn on or o the cell ringer feature:
1. Press MENU on the telephone base in idle mode.
2. Press CID or DIR to highlight Bluetooth, then
press SELECT.
3. Press CID or DIR to highlight Cell ringer, then
press SELECT.
f If there is more than one paired device on the device
list, press CID or DIR to highlight the desired device,
then press SELECT.
4. Press CID or DIR to choose On or O, then press SET.
Note: The quality of ringtone played on your telephone is subject to individual ringtone characteristics.
ENTER NEW PIN
0000
BACK SET
BLUETOOTH
Device list
Download dir
Change PIN
BACK SELECT
CELL RINGER
On
Off
Cell ringer
BACK SET
BLUETOOTH
Download dir
Change PIN
Cell ringer
BACK SELECT
To Next Page
Loading...
Need help?
General
