AT&T TL96457 User Manual

29
Bluetooth
Bluetooth setup
Replace an active device
If you already have two active devices on the device list and you want to

To replace an active device:
1. Press MENU on the telephone base in idle mode.
2. Press CID or DIR to highlight Bluetooth, then
press SELECT.
3. Press CID or DIR to highlight Device list, then
press SELECT.
4. Press CID or DIR to highlight the device you want to
D1: or D2:, then press OPTION.
5. Press CID or DIR to highlight Connect, then press
SELECT. The handset displays Only BT devices in slot 1 or
2 can be ready for connection and then a list of devices
for deactivation.
6. Press CID or DIR to highlight the device to be
deactivated, then press NEXT. The screen displays
Cell Phone X is deactivated
tone. Then, the screen displays Connecting Cell Phone Y
to the base... (Cell Phone X and Cell Phone Y represent
the device names of your cell phones) .
7. Depending on your cell phone settings, you may need to

When the new device is successfully activated and
connected, the handset displays Device connected
tone.
Note: When connecting a Bluetooth device to the device list, all connected devices will be temporarily
disconnected until the procedure is complete. It may take up to two minutes to reconnect.
DEVICE LIST
D1:Cell Phone Y
D2:Headset X
Cell Phone X
BACK OPTION
DEACTIVATE
D1:Cell Phone X
D2:Headset X
BACK NEXT
DEVICE LIST
D1:Cell Phone X
D2:Headset X
Cell Phone Y
BACK OPTION
Connecting
Cell Phone Y
to the base...
Only BT devices
in slot 1 or 2
can be ready
for connection

AT&T TL96457 Specifications

General

Brand	AT&T
Model	TL96457
Category	IP Phone
Language	English