156
Answering system
Message playback
When messages are playing on a handset:
f Press /SPEAKER to play the messages through the handset earpiece.
Press /SPEAKER again to return to playing messages through the
speakerphone.
f Press CID
/
VOLUME/
DIR
to adjust the message playback volume.
f Press SKIP to skip to the next message.
f Press REPEAT to repeat the message currently playing. Press REPEAT twice
to listen to the previous message.
f Press MUTE/DELETE to delete the current message.
f Press 2 to pause the playback and show the caller ID information.
f Press HOME/FLASH, CALL or /SPEAKER to use the home line, or
press CELL 1 or CELL 2 to use the cell line to call back the caller. If
necessary, press
#
(pound key) or 1
f Press OFF/CANCEL or BACK to restart the playback. If you do not call
back within 10 seconds, message playback restarts.
f Press HOME/FLASH, CELL 1 or CELL 2 to pause the message playback.
The handset displays Call back? with the caller ID information. Press CALL
to call back the caller, or BACK to restart the message playback. If the dialing
format used is not correct, then use the option, as mentioned above, to
choose the correct dialing format before calling back the caller.
f Press OFF/CANCEL to stop the playback.
Notes:
f When the answering system has less than three minutes of recording time le, it announces, “Less than three minutes
to record.” and the handset displays Rec mem low.
f When the telephone is not in use, if the handset or telephone base displays Rec mem full, the memory is full.
Delete some messages to make room for more.
To Next Page
Loading...
Need help?
General
