162
Appendix
Add and register handsets/headsets/speakerphones
If registration fails, the system will automatically try to register again. If
Registration failed appears on both
screens. The handset shows To register, see user manual and the telephone
start again from Step 1.
Method 2:
1. Press and hold /FIND HS on the telephone base for about four seconds
and it shows Registering... Please wait. Release /FIND HS.
2. Press QUIET # on the handset. The handset shows Registering... Please
wait. If the registration is successful, both the handset and the telephone
base screens display HANDSET X Registered (HANDSET represents the
handset name, X represents the handset number). Both the handset and the
telephone base beep. The handset is now registered with the
telephone base.
If registration fails, Registration failed appears on both screens. The handset
shows To register, see user manual and the telephone base returns to idle
Step 1.
Notes:
f You cannot register a handset if any other system handset is in use.
f If you try to register more than 12 handsets to the telephone base, the telephone base shows Registration slots
are full and sounds two beeps.
To Next Page
Loading...
Need help?
General
