80
Multiple handset use
Push-to-talk (PTT)
Using the telephone base:
1. There are a few ways to begin a PTT call to a single handset. When the
telephone base is not in use:
f If you have one handset, press and hold PT T/FLASH in idle mode.
f If you have more than one handset, press PTT/FLASH in idle mode:
Use the dialing keys to enter the destination handset number (1-9 for
handsets 1-9, TONE and 0 for handset 10, TONE and 1 for handset 11
or TONE and 2 for handset 12).
-OR-
Press CID or DIR to scroll to the destination device, then press
SELECT or PT T/FLASH.
Your telephone base displays Connecting to HANDSET X... (HANDSET
represents the handset name, X represents the destination handset number)
for a few seconds. When the connection is made, both the telephone base
and the destination handset display Press and hold [PTT] to talk and beep
once.
2. Press and hold
PT T/FLASH
. A chirp indicates your microphone is on. Speak
towards the telephone base. Your voice is broadcast to the destination
handset. While you are speaking, the telephone base displays PTT To
HANDSET X (X represents the destination handset number).
3. Release
PT T/FLASH
screens show Press and hold [PTT] to talk, then you can press and hold
PT T/FLASH
to continue speaking or the destination handsets can respond
(see Answer a PTT call on page 83).
4. To end the PTT call, press CANCEL or END. The telephone base shows Push
to talk Ended for a few seconds.
Note: Aer PT T/FLASH is released, the PTT call remains open for a short time. If no one presses PT T/FLASH
within 10 seconds, the PTT call ends automatically.
To Next Page
Loading...
Need help?
General
