82
Multiple handset use
Push-to-talk (PTT)
Using the telephone base:
1. You have two ways to call multiple handsets. When the telephone base is not
in use:
f Press and hold PTT/ FLASH until the telephone base shows Connecting to
group....
-OR-
f Press PTT/ FLASH in idle mode. Press CID or DIR to highlight Group, then
press SELECT or PTT/FLASH.
Your telephone base displays Connecting to group... for a few seconds.
When the connection is made, the telephone base and all destination
handsets display Press and hold [PTT] to talk and beep once.
2. Press and hold PTT/ FLASH on the telephone base. A chirp indicates your
microphone is on. Speak towards the telephone base. Your voice is broadcast
to all devices.
3. Release PT T/FLASH
telephone base beeps, you can press and hold PTT/FLASH to continue
speaking or the destination handsets can respond (see Answer a PTT call on
page 83
).
4. Press
CANCEL
or END to end the PTT call. All devices display Push to talk
Ended for a few seconds.
Note: Aer PT T/FLASH is released, the PTT call remains open for a short time. If no one presses PT T/FLASH
within 10 seconds, the PTT call ends automatically.