Model X High Speed Sublimation printer
6
Make sure the power cord is securely plugged into a power outlet.
Doing so may cause a fire or short circuit.
Do not use a power cord that is different from the one provided by the printer.
Doing so may cause a fire or short circuit.
Pay attention to the following points when connecting the grounding.
Allowed ground wire
• Power supply ground terminal
• Intact pile ground
Ground wire that is not allowed to be connected
• Water pipe
• Gas pipe
• Telephone line and lightning protection wire
CAUTION
Use the appropriate supply voltage as described.
Failure to use the specified power supply voltage may result in fire or short circuit.
When disconnecting the power cord, be sure to pull the plug, not the cord itself.
Do not use an additional power cord in general.
If using an additional power cord, remember that the total amperage of the device
plugged into the additional power cord does not exceed the rated amperage of the
power source. Also, remember that the total amperage of all equipment plugged into
the wall does not exceed the rated amperage of the wall outlet.
Make sure the power plug can be easily removed at any time, ensure that no objects are
placed around it.
Ensure good grounding
To Next Page
Loading...
