Atlas Copco FOCUS 60

Focus 60 / Focus 61 User Guide Introduction
9839 0211 01 Edition 1.1 13 (106)
NOTE: Connect the SIP/SOP of the Focus 60 / Focus 61 ONLY with devices in compliance
with the following harmonized standards:
 IEC EN 60950-1:2005 + A1:2009
+ A2:2013
Safety of electronic equipment within the field of
audio/video, information technology and
communication technology. General requirements.
 IEC EN 61010-1:2010
Safety requirements for electrical equipment for
measurement, control, and laboratory use. General
requirements.
NOTE: The internal battery of the Focus 60 / Focus 61 is in conformity with the following
harmonized standard:
 IEC 60086-1:2015
Primary batteries – Part 1: General.
1.5 FCC/ IC
Changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS
standard(s).
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence.
L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.