Focus 60 / Focus 61 Settings Focus 60 / Focus 61 User Guide
92 (106) 9839 0211 01 Edition 1.1
10.2.4 Display Settings
Set both the Brightness and Contrast on the Focus 60 /
Focus 61 from the related section placed in the Display
Settings (refer to the screen below) and click respectively
“Brightness” and “Contrast” to confirm:
10.3 Network Adapters Configuration
The Network Adapters menu (place in the Device Files area)
configures the Ethernet Ports A and B.
NOTE: It is MANDATORY to connect the Focus
60 / Focus 61 with ToolsTalk BLM before to
access the Network Adapters Configuration.
Select ETH_A or ETH_B option. This ports are defined in
the reference protocol.
The Ethernet Properties pop-up on the right shows:
Configure the Network Parameters (IP Address, Netmask,
Gateway), enable or disable the DHCP and click Save to confirm.
To Next Page
Loading...
