Atlas Copco FOCUS 60

Focus 60 / Focus 61 User Guide User Interfaces
9839 0211 01 Edition 1.1 21 (106)
Associate the MWR-TA with a Station of the Focus 60 / Focus 61. After few seconds, the Focus 60 /
Focus 61 shows the data of the ongoing tightening operation on the MWR-TA (refer to the following
picture):
MWR-TA serial number
Serial number of the MWR-TA that is working.
Torque peak
Maximum torque measured during tightening phase.
Torque click
Click-point measured during tightening phase.
Status
Result of tightening operation of the operating MWR-TA.
NOTE: Refer to the paragraph “Executing tightening operations”
for further details.
Angle
Maximum angle measured during the tightening phase.
Batch counter
Number of the current tightening over the job step total tightenings.
4.2 Focus 60 / Focus 61 Keyboard
Use the keyboard to browse the Focus 60 / Focus 61menu and to change the info screens:
Torque peak
Torque click
Angle
Status
Batch counter
MWR-TA
serial number