Atlas Copco FOCUS 60 - Focus 60; Focus 61 I; O BUS (CAN)

User Interface Focus 60 / Focus 61 User Guide
26 (106) 9839 0211 01 Edition 1.1
4.6 Focus 60 / Focus 61 I / O BUS (CAN)
I / O BUS (CAN) (see the pictures below) connects the Stacklight to the Focus 60 / Focus 61. The
Stacklight is an optional tool that supplies a real time indication of each tightening result, system status,
etc.
I / O BUS (CAN) parameters are as follows:
 Data Rate: 250000 bit/s
 Address range: 1…f
 Current at 24V: 250mA (maximum)
 Pin assignment I/O BUS (CAN):
PIN #
Signal
1
+24 VDC
2
Data Low
3
GND
4
GND
5
6
GND
7
Data High
8
9
+9 VDC
NOTE: All signals and voltages are galvanically separated from the device.