NOTICE ToolsTalk BLM Software runs also with Windows Standard User, except for the
following issue:
Log management
To avoid the previous issue, run ToolsTalk BLM as Administrator.
If the user does not run ToolsTalk BLM
with Administrator rights, the pop-up on
the right shows:
Click Yes to continue as Standard User: in
this case, the user could encounter issues
in some functionalities.
5.2 Software registration
After installing the software, register at
www.atlascopco.com/tools/software; if there is no registration,
the software works as demo for 60 days.
Once the software is installed, enter the registration form by
selecting Start → All Programs → Atlas Copco Tools AB →
ACTLicense (refer to the screen on the right).
5.3 Software upgrade
If there is a software update of ToolsTalk BLM, simply install the new version; the previous one is
automatically uninstalled.
Close the previous version during the update process.
There is no impact through the update on the settings, tightening programs and results.
To Next Page
Loading...
