Focus 60 / Focus 61 User Guide Executing Tightening Operations
9839 0211 01 Edition 1.1 77 (106)
7 EXECUTING TIGHTENING OPERATIONS
NOTE: No effects resulting from special conditions should be detected when the Focus 60 /
Focus 61 is integrated into systems.
Once the Focus 61 is configured as described in the previous paragraph “Programming Focus 60 / Focus
61”, it is possible to start a Job on the Station(s).
On each station, only one MWR-TA can work at a time.
The Job associated with each MWR-TA starts depending from the Event settings.
NOTE: Refer to the paragraph “Associating the MWR wrenches with Station(s)” for further
details about the LED indication on the MWR-TA.
The tightening results are visible on
the Focus 60 / Focus 61 display and
on the stacklight (see the figure on
the right).
Execute the tightening,
when blue LED flashes
To Next Page
Loading...
