Focus 60 / Focus 61 User Guide Programming Focus 60 / Focus 61
9839 0211 01 Edition 1.1 63 (106)
6.4 Job Configuration
The Job is a set of tightening operations (steps) performed by the MWR-TA associated with a station.
Each MWR-TA must be configured with its Pset as described in the paragraph above.
Double-click Add Job (see the figure above) to create a new Job.
To remove a Job either double-click and select Delete or drag and drop the Job into the trash bin.
Job Settings area configures the Job according to the following parameters:
To Next Page
Loading...
