Atlas Copco FOCUS 60

Programming Focus 60 / Focus 61 Focus 60 / Focus 61 User Guide
48 (106) 9839 0211 01 Edition 1.1
6 PROGRAMMING Focus 60 / Focus 61
The Focus 61 can manage one or two stations, while the Focus 60 can manage only one station.
The stations are virtual, used by the software to let the device manage the jobs of the operators working,
for instance, of the two sides of the same assembly area (in the case of the Focus 61).
For each station, the sequence of operations that the operator must execute is defined into one or more
Jobs. Each Job is a set of Pset, which is the tightening program loaded on the MWR-TA.
NOTE: The Focus 60 can ONLY handle one Job and one Pset.
Programming of Stations,
Jobs, Psets and Events
Events
One MWR-TA for
each station
One or more
Jobs for each
station
The Focus 61 can manage one or
two stations.
The Focus 60 can manage
ONLY one station.
One or more
Jobs for each
station
One MWR-TA for
each station
Station 2
Station 1
ToolsTalk BLM