Programming Focus 60 / Focus 61 Focus 60 / Focus 61 User Guide
76 (106) 9839 0211 01 Edition 1.1
3. Select the event condition. After selecting the event condition, the editable section on
the right of the Setup screen gets automatically active (refer to the following screen):
The āBehaviuor columnā summarizes the editable section.
Configure the editable section by setting temporary intervals of flashes and signal
duration. Finally click Set (placed on the lower right corner of the editable section).
It is possible to set up to 10 event conditions.
NOTE: It is not recommended selecting event conditions that do not agree
(for instance Tightening OK and Tightening NOK).
NOTE: The pop-up on the
right shows, after reaching
the maximum number of
configurable events:
After configuring the necessary event conditions, click Save (placed on the lower
right corner of the Setup screen).
After setting the Stacklight, click Save (placed on the upper left corner of the New Accessory window).
To Next Page
Loading...
