Atlas Copco FOCUS 60 - Page 70

Programming Focus 60 / Focus 61 Focus 60 / Focus 61 User Guide
70 (106) 9839 0211 01 Edition 1.1
DEVICE
Type
Accessory used
Available
Stacklights
This drop-down list selects the ID channel to use in order to configure the
accessory
CONFIGURATION
Lamp
“Lamp” section configures the behavior of each lamp. The Stacklight mounts up to 5
configurable lamps.
Do the following procedure to configure “Lamp” section.
1. Starting from Lamp 1, check the box in correspondence of “Mounted”: a lamp
shows on the Stacklight on the left (see the figures below):
NOTE: Configure the lamps of the Stacklight starting from lamp 1 to lamp 5
(in ascending order). Only the last configured lamp is editable.
For instance, after configuring all of the lamps, to edit lamp 3, it is necessary
to disable the last configured lamps in this sequence: lamp 5 – lamp 4.
To disable a lamp, remove the check mark in correspondence of “Mounted”.
2. Open the drop-down list (placed below
“Mounted” option) and select between the
following options:
Not Configured, White, Red, Green, Yellow,
Blue, Red Rotating, Yellow Rotating, Siren.
After setting the configuration, the lamp on the
Stacklight is automatically colored according to
the option selected.
After checking the box
in correspondence of
“Mounted”, a lamp
shows on the Stacklight