Atlas Copco FOCUS 60 - Page 98

Working with Open Protocol Focus 60 / Focus 61 User Guide
98 (106) 9839 0211 01 Edition 1.1
In the third step the VIN (Vehicle ID Number) is subscribed by the Atlas Open Protocol. This means that
every time when the controller receives a new VIN (e.g. via barcode scanner), this VIN is transmitted to
Atlas Open Protocol.
The fourth step contains the MID to request the latest VIN from the controller.
At the certain time the Job starts by a trigger, e.g. barcode, where a new VIN is set.
In the last step this VIN is transferred via MID 0052 to the Atlas Open Protocol.
NOTE: It is MANDATORY to specify into the message MID 0051 the Station ID (0 or 1).
Atlas Open Protocol
First Step
MID 0001 – Communication start
MID 0002
Second
Step
Third
Step
MID 0051- Vehicle ID Number subscribe
Fourth
Step
MID 0050 – Vehicle ID Number download
request
JOB STARTS
MID 0052 - Vehicle ID Number
Fifth
Step
NOTE: The procedures above explained consider an Event Type set to AOP_SETVIN during the
configuration of the Event.
If the Event Type is set to AOP_IDENTIFIER, the two procedures are the same, except the
following conditions:
- MID 0050 – Vehicle ID Number download request is replaced by MID 0150 – Identifier
download request
- MID 0051 – Vehicle ID Number subscribe is replaced by MID 0151 – Identifier subscribe
- MID 0052 – Vehicle ID Number is replaced by MID 0152 – Identifier