EasyManuals Logo

Atlas Copco HiLight B6+ Kd ESF User Manual

Atlas Copco HiLight B6+ Kd ESF
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #64 background imageLoading...
Page #64 background image
- 64 -
6 Checks and
troubleshooting
6.1 Engine troubleshooting
Refer to the Engine Operation manual for engine
troubleshooting.
6.2 Solving controller alarms
6.2.1 General
If an alarm condition occurs, an icon is displayed in
the Alarm Icon section of the Lc1003™ LCD to
indicate the alarm that is current active on the
controller.
In the event of a warning alarm, the LCD only
displays the Alarm Icon.
In the event of an electrical trip or shutdown alarm,
the module displays the Alarm Icon and the STOP
button LED begins to flash.
If multiple alarms are active at the same time, the
Alarm Icon automatically cycles through all the
appropriate icons to indicate each alarm which is
active.
Never perform a test run with
connected power cables. Never
touch an electrical connector
without a voltage check.
When a failure occurs, always
report what you experienced before,
during and after the failure.
Information with regard to the load
(type, size, power factor, etc.),
vibrations, exhaust gas colour,
insulation check, odours, output
voltage, leaks and damaged parts,
ambient temperature, daily and
normal maintenance and altitude
might be helpful to quickly locate
the problem. Also report any
information regarding the humidity
and location of the light tower (e.g.
close to sea).
00_00_HiLight B6+_EN.book Page 64 Thursday, September 2, 2021 11:50 AM

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Atlas Copco HiLight B6+ Kd ESF and is the answer not in the manual?

Atlas Copco HiLight B6+ Kd ESF Specifications

General IconGeneral
BrandAtlas Copco
ModelHiLight B6+ Kd ESF
CategoryLighting Equipment
LanguageEnglish

Related product manuals