- 24 -
3.2.2 Positioning for transport
1. Make sure the mast is lowered completely and
turned 90° (1). See also chapter “Lowering the
mast” on page 34.
2. Use the handle at the top of each foot to retract the
4 feet (2).
3. Retract the stabilizers (3) and ensure their locking
pins (4) following the reverse order of the
procedure described in “Positioning for
operation” on page 22.
Once all the above operations are completed, the light
tower is ready for transport as shown in the figure
above.
Adjust the height of the supporting
feet gradually in order to ensure the
stability of the unit.
00_00_HiLight B6+_EN.book Page 24 Thursday, September 2, 2021 11:50 AM
To Next Page
Loading...
Need help?
General
