Atlas Copco HiLight B6+ Kd ESF User Manual

- 69 -
Battery Over Voltage The DC supply has risen above the high volts setting level.
Generator Under Voltage
The generator output voltage has fallen below the pre-set pre-alarm setting after the Safety On
timer has expired
Generator Over Voltage The generator output voltage has risen above the pre-set pre-alarm setting.
Generator Under Frequency
The generator output frequency has fallen below the pre-set pre-alarm setting after the Safety
On timer has expired.
Generator Over Frequency The generator output frequency has risen above the pre-set pre-alarm setting.
Emergency Stop
The emergency stop button has been depressed. This fail-safe (normally closed to emergency
stop) input immediately stops the set, should the signal be removed.
Oil Sender Open Circuit The oil pressure sensor has been detected as being open circuit.
Coolant Temperature Sender Open Circuit The coolant temperature sensor has been detected as being open circuit.
Delayed Over Current The measured current has risen above the configured trip level for a configured duration.
Low Current
The measured current has fallen below the configured trip level. This is used to detect lamp
failure.
Display Description Reason
00_00_HiLight B6+_EN.book Page 69 Thursday, September 2, 2021 11:50 AM

Atlas Copco HiLight B6+ Kd ESF Specifications

General

Brand	Atlas Copco
Model	HiLight B6+ Kd ESF
Category	Lighting Equipment
Language	English