Atop ABLEPick AT500 - 4.3.3 Turn LED indicator ON; 4.3.4 Turn LED indicator OFF; 4.3.5 Turn Buzzer ON

ABLEPick pick-to-light communication protocol
23
Reserved
Reserved
SUB-COMMAND = 01H
SUB-NODE = {01H ~ FAH}
0x01~0xFA (address)
or 0xFC (Broadcasting)
Sub-command = 01H also can be used to eliminate the display buffers, such as for
AT503A, AT502V, AT50C/AT70C,AT506-3W-123, AT506-2W-33A, AT50A-3W-523…etc.
And if send to the other models, like AT505/AT705, AT703, AT502/AT702,
AT506-2W-33…etc, then the message for redisplay is also reset, in other words, redisplay
won’t work after 01H..
4.3.3 Turn LED indicator ON
SUB-COMMAND = 02H
CCB LEN (L) = 08H
Data length of this block
CCB LEN (H) = 00H
MESSAGE TYPE = 60H
60H : port 1
Reserved
Reserved
Reserved
SUB-COMMAND = 02H
SUB-NODE = {01H ~ FAH}
0x01~0xFA (address)
or 0xFC (Broadcasting)
Turn on all the LED light, for AT50C/AT70C, there is a little difference, please refer 4.5.1.2.
4.3.4 Turn LED indicator OFF
SUB-COMMAND = 03H
CCB LEN (L) = 08H
Data length of this block
CCB LEN (H) = 00H
MESSAGE TYPE = 60H
60H : port 1
Reserved
Reserved
Reserved
SUB-COMMAND = 03H
SUB-NODE = {01H ~ FAH}
0x01~0xFA (address)
or 0xFC (Broadcasting)
4.3.5 Turn Buzzer ON
SUB-COMMAND = 04H
CCB LEN (L) = 08H
Data length of this block
CCB LEN (H) = 00H
MESSAGE TYPE = 60H
60H : port 1
Reserved
Reserved
Reserved
SUB-COMMAND = 04H
SUB-NODE = {01H ~ FAH}
0x01~0xFA (address)
or 0xFC (Broadcasting)
Turn on the buzzer of AT510 and Melody of AT510M/AT710M, not for AT50C/AT70C’s