Atop ABLEPick AT500 - 4.4.4 Returning a device malfunction; 4.4.5 Returning an illegal command; 4.4.6 Returning push-button locked message; 4.4.7 Returning a device resetting OK

ABLEPick pick-to-light communication protocol
38
SUB-NODE = {01H ~ FAH}
Device address
4.4.4 Returning a device malfunction
Return a message back to host when the device is malfunction
SUB-COMMAND = 0BH
CCB LEN (L) = 08H
Data length of this block
CCB LEN (H) = 00H
(8 Bytes)
MESSAGE TYPE =60H
60H : port 1
Reserved
Reserved
Reserved
SUB-COMMAND = 0BH
SUB-NODE = {01H ~ FAH}
Device address
4.4.5 Returning an illegal command
Return a message back to host when TCP/IP controller receive an illegal sub-command
sent from host.
SUB-COMMAND = 0CH
CCB LEN (L) = 08H
Data length of this block
CCB LEN (H) = 00H
(8 Bytes)
MESSAGE TYPE =60H
60H : port 1
Reserved
Reserved
Reserved
SUB-COMMAND = 0CH
SUB-NODE = {01H ~ FAH}
Device address
4.4.6 Returning push-button locked message
When the tag receive command message from host PC and the tag’s push-button is on the
status during the time pressed and not release yet, the locked message will be prompted
SUB-COMMAND = 0DH
CCB LEN (L) = 08H
Data length of this block
CCB LEN (H) = 00H
(8 Bytes)
MESSAGE TYPE =60H
60H : port 1
Reserved
Reserved
Reserved
SUB-COMMAND = 0DH
SUB-NODE = {01H ~ FAH}
Device address
4.4.7 Returning a device resetting OK
When a device received the Resetting request command (SUB-COMMAND = 14H) and
reset successfully, it returned this message to the Host. If the Host does not get this
message after sending the Resetting request command in a timeout period, then the
device has failed to reset.
SUB-COMMAND = 0EH