Atop ABLEPick AT500 - Enable;Disable the Alarm Auto-Buzzer Function

ABLEPick pick-to-light communication protocol
65
6.4 Enable/Disable the alarm auto-buzzer function
If any alarm event occurred, the AT400 can alarm by buzzer automatically. (Default: Enable
the alarm auto-report function)
SUB-COMMAND = F7H
CCB Description
CCB LEN(L)= 0AH
Length of CCB = 10 bytes
CCB LEN(H) =00H
MESSAGE TYPE = 60H
60H: port1 of controller,
Reserved
Reserved
Reserved
SUB-COMMAND
F7H
SUB-NODE
00H
Message Type
02H : Set/Get the alarm auto
buzzer mode
Data(0)
Mode type
DATA[0] = Set/Get the alarm auto-report mode
00H  Get the alarm auto-buzzer mode
01H  enable the alarm auto-buzzer mode
02H  disable the alarm auto-buzzer mode
6.4.1 Return the alarm auto-buzzer mode
SUB-COMMAND = F7H
CCB Description
CCB LEN(L)= 0AH
Length of CCB = 10 bytes
CCB LEN(H) =00H
MESSAGE TYPE = 60H
60H: port1 of controller,
Reserved
Reserved
Reserved
SUB-COMMAND
F7H
SUB-NODE
00H
Message Type
02H : Get the alarm auto-buzzer
mode
Data(0)
Mode type
DATA[0] = Get the alarm auto-buzzer mode
00H  the alarm auto-buzzer mode is disabled
01H  the alarm auto-buzzer mode is enabled