Atop ABLEPick AT500 - 6.4 Enable;Disable the alarm auto-buzzer function; 6.4.1 Return the alarm auto-buzzer mode

ABLEPick pick-to-light communication protocol
64
Bit 0  Input Voltage too low
Bit 1  Input Voltage too high
Bit 2  reserved
Bit 3  reserved
Bit 4  reserved
Bit 5  reserved
Bit 6  reserved
Bit 7  System abnormal
DATA[2~9] = Reserved
6.3 Enable/Disable the alarm auto-report function
If any alarm status is changed, the AT400 can send the alarm status message
automatically (Default: Disable the alarm auto-report function) . The status message format
is the same as the return message of the 'Read alarm status' command
SUB-COMMAND = F7H
CCB Description
CCB LEN(L)= 0AH
Length of CCB = 10 bytes
CCB LEN(H) =00H
MESSAGE TYPE = 60H
60H: port1 of controller,
Reserved
Reserved
Reserved
SUB-COMMAND
F7H
SUB-NODE
00H
Message Type
01H : Set/Get the alarm auto-report
mode
Data(0)
Mode type
DATA[0] = Set/Get the alarm auto-report mode
00H  Get the alarm auto-report mode
01H  enable the alarm auto-report mode
02H  disable the alarm auto-report mode
6.3.1 Return the alarm auto-report mode
SUB-COMMAND = F7H
CCB Description
CCB LEN(L)= 0AH
Length of CCB = 10 bytes
CCB LEN(H) =00H
MESSAGE TYPE = 60H
60H: port1 of controller,
Reserved
Reserved
Reserved
SUB-COMMAND
F7H
SUB-NODE
00H
Message Type
01H : Get the alarm auto-report
mode
Data(0)
Mode type
DATA[0] = Get the alarm auto-report mode
00H  the alarm auto-report mode is disabled
01H  the alarm auto-report mode is enabled