Atop ABLEPick AT500 - Page 3

ABLEPick pick-to-light communication protocol
2
4. ABLEPICK TCP/IP COMMUNICATION PROTOCOL .................................................................. 20
4.1 COMMUNICATION CONTROL BLOCK (CCB) FORMAT...................................................................... 20
4.2 SUB-COMMAND LIST ....................................................................................................................... 20
4.3 SEND COMMAND TO TAGS (PCTCP/IP CONTROLLER).............................................................. 21
4.3.1 Showing alphanumerical characters on 7-segment LED display.................................. 22
4.3.2 Turn off 7-segment LED dispisplay or clear all message buffers.................................. 22
4.3.3 Turn LED indicator ON ........................................................................................................ 23
4.3.4 Turn LED indicator OFF ...................................................................................................... 23
4.3.5 Turn Buzzer ON.................................................................................................................... 23
4.3.6 Turn Buzzer OFF.................................................................................................................. 24
4.3.7 Flashing the display on 7-segment LED display ............................................................. 24
4.3.8 Flashing the LED indicator.................................................................................................. 24
4.3.9 Configure the flashing time interval ................................................................................... 25
4.3.10 Showing tag’s node address on display ......................................................................... 25
4.3.11 Disable the shortage/down-count button ........................................................................ 25
4.3.12 Enable the shortage/down-count button......................................................................... 26
4.3.13 Emulating push confirmation button................................................................................ 26
4.3.14 Emulating push shortage/down-count button ................................................................ 26
4.3.15 Switching to stock mode ................................................................................................... 26
4.3.16 Switching to picking mode ................................................................................................ 27
4.3.17 Disable the confirmation button ....................................................................................... 27
4.3.18 Enable confirmation button............................................................................................... 27
4.3.19 Set available number of digits for up/down counting .................................................... 27
4.3.20 Set Tag’s specific configuration........................................................................................ 28
4.3.21 Get device’s F/W model information ............................................................................... 34
4.3.22 Get device’s detail configured information ..................................................................... 34
4.3.23 Configure the TCP/IP controller’s polling range ............................................................ 35
4.3.23 Getting all the device’s status under one TCP/IP controller ........................................ 35
4.3.24 Asking device to reset ....................................................................................................... 35
4.3.25 Configure the device’s node address.............................................................................. 36
4.4 RECEIVE MESSAGE FROM TAGS (PCTCP/IP CONTROLLER)..................................................... 36
4.4.1 Returning confirmation message from push-button........................................................ 36
4.4.2 Returning shortage message from push-button .............................................................. 37
4.4.3 Returning device timeout .................................................................................................... 37
4.4.4 Returning a device malfunction.......................................................................................... 38
4.4.5 Returning an illegal command............................................................................................ 38
4.4.6 Returning push-button locked message ........................................................................... 38
4.4.7 Returning a device resetting OK........................................................................................ 38