Atop ABLEPick AT500 - 4.5.6.9 Tag mode configuration; 4.5.6.10 AT503-4 K auto-demonstrating function

ABLEPick pick-to-light communication protocol
56
Data 1
Delay time (default=02H, 00H ~
0FH )
This function will define the valid & successful pressing on the button on two contiguous
pressing. The default value of Data1 = 02H, And the actual delay time will be 0.4sec * Data
1, in other words, the default delay time is 0.8 sec for a valid action on the button between
two contiguous pressing.
4.5.6.9 Tag mode configuration
Please refer the 4.3.20.3 & 4.3.20.4
4.5.6.10 AT503-4K auto-demonstrating function
CCB Description
CCB LEN(L)= length of CCB
Length of CCB in byte
CCB LEN(H) = 0x00
MESSAGE TYPE = 0x60
0x60: port1 of controller,
Reserved
Reserved
Reserved
SUB-COMMAND
32H
SUB-NODE
0x01~0xFA (address)
or 0xFC (Broadcasting)
Data 0
define buffer index and its specific
light’s status
Data 1
Display swapping time interval
Data 2
5
th
digit in LED
Data 3
4
th
digit in LED
Data 4
3
rd
digit in LED
Data 5
2
nd
digit in LED
Data 6
1
st
digit in LED
Dot
Dot position
1) Data 0: Define the buffer index of sending data and its specific illuminant button’s
status. Bit assignment of Byte is as below.
Bit 0 : LED status
Bit 1 : LED status
Bit 2 : LED status
Bit 3 : reserved
Bit 4 : Buffer index
Bit 5 : Buffer index
Bit 6 : reserved
Bit 7 : reserved
Bit assignment:
7
6
5
4
3
2
1
0
0 0 0-------- delete the this buffer data.
0 0 1-------- Light is ON
0 1 0-------- Light is blinking by 2 second interval
0 1 1-------- Light is blinking by 1 second interval
1 0 0-------- Light is blinking by 0.5 second interval
1 0 1-------- Light is blinking by 0.25 second interval
0 0-------------------------------- assign to 1
st
button
0 1-------------------------------- assign to 2
nd
button
1 0--------------------------------- assign to 3
rd
button