Audi A3 1997 - Checking Condensation Drain, Removing and Installing Valve; Removing and Installing Radiator Fan Control Unit -J293

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
5.2 - Removing and installing radiator fan control unit -J293
- -> Detach connectors-A- and -B-.
- Remove bolts -C-.
Notes:
◆ Radiator fan control unit -J293 versions and vehicle wiring differ for vehicles with pressure switch -F129 and
high-pressure sensor -G65.
=> Parts List
=> Current Flow Diagrams, Electrical Fault-Finding and Fitting Locations
◆ Control unit -J293, installed in vehicles with high-pressure sensor -G65, is available in 2 designs.
- - In design "1" the radiator fan is automatically switched on in conjunction with the compressor (the first
fan speed is activated regardless of the pressure in the refrigerant circuit).
- In design "2" the compressor is switched on without the radiator fan; the first fan speed is only activated
once the pressure in the refrigerant circuit has exceeded 12 bar.
5.3 - Checking condensation drain, removing and installing valve
Checking
- -> Condensation drain valve -A- must not be gummed up and must close; the drainage aperture must be
positioned at bottom.
Audi A3 1997 ➤
Heating, Air Conditioner - Edition 06.2000
5.2 - Removing and installing radiator fan control unit -J293 161