Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
1.6 - Removing and installing windscreen defroster vent
- Remove dash panel fascia.
=> Inner Body Assembly; Repair group 70
- -> Remove speed nuts -A- and detach defroster vent -B-from dash panel fascia.
1.7 - Checking vent frame
- -> The sealing lips -B- in the vent frame -A- must move freely and close automatically.
Notes:
◆ The illustrations show the vent frame after removal of the rear bumper.
◆ The vehicle is fitted with two vent frames (left and right) for forced air extraction.
◆ In order for the vehicle interior ventilation to work properly, the air ducts which run through the luggage
compartment trim must be unobstructed.
Audi A3 1997 ➤
Heating, Air Conditioner - Edition 06.2000
1.5 - Removing and installing "left" and "right" dash panel vent 93
To Next Page
Loading...
