Audi A3 1997 - End Output; Erase Fault Memory; Erasing Fault Memory, Ending Output

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
7 - Erasing fault memory, ending output
7.1 - Erasing fault memory, ending output
Prerequisite
◆ Fault memory interrogated.
Erasing fault memory
- Press ⇒ key.
-> Indicated on display (function selection):
Rapid data transfer HELP
Select function XX
- Press keys -0- and -5- (05 selects the "Erase fault memory" function.)
-> Indicated on display:
Rapid data transfer Q
05 - Erase fault memory
- Press Q to confirm entry.
-> Display:
Rapid data transfer Q
Fault memory is erased
- Press the ⇒ key.
-> Indicated on display:
Rapid data transfer HELP
Select function XX
Notes:
◆
Important:
Fault memory has not been interrogated
-> If the text below appears on the display, an error has occurred in the test sequence.
◆ Observe test sequence exactly:
- Interrogate fault memory
- Rectify any faults.
- Delete fault memory.
◆ The fault memory is not erased if, for example, the ignition was switched off between "Interrogating fault
memory" and "Erase fault memory" (interrogate fault memory again).
End of output
Note:
The fault memory has been interrogated and erased, basic setting has been performed, and the encoding has
been checked.
-> Indicated on display:
Rapid data transfer HELP
Select function XX
- Press keys -0- and -6- (06 selects the "End output" function).
-> Indicated on display:
Audi A3 1997 ➤
Heating, Air Conditioner - Edition 06.2000
26 01 - Self-diagnosis, Electrical check