Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6.14 - Removing and installing fresh air intake temperature sensor -G89
- Remove dust and pollen filter => Page 113
- Remove glove compartment.
=> Inner Body Assembly; Repair group 68
- -> Reach into the intake housing and turn temperature sensor -A- 90°.
- Reach between air conditioner and A-pillar and remove temperature sensor from the intake with connector
-C- attached.
Notes:
◆ If the temperature sensor cannot be turned, carefully spray silicone spray onto contact surface of rubber
grommet -B-.
◆ Checking =>Electrical check, Page 46 .
6.15 - Removing and installing air flow flap positioning motor -V71
Notes:
This positioning motor actuates the air flow flap and fresh/recirculated air flap.
- Remove glove compartment.
=> Inner Body Assembly; Repair group 68
- -> Carefully unclip operating lever -A- (to air flow flap) using a screwdriver.
Audi A3 1997 ➤
Heating, Air Conditioner - Edition 06.2000
6.14 - Removing and installing fresh air intake temperature sensor -G89 185
To Next Page
Loading...
