Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
6.12 - Removing and installing dash panel temperature sensor -G56
- Remove radio.
=> Electrical System; Repair group 91
- Remove panel for dash panel centre section.
=> Inner Body Assembly; Repair group 68
- -> Disconnect intake hose -B-.
- Remove temperature sensor housing -A- from the retainer.
Notes:
◆ Temperature sensor -C- must not make contact with housing -A-.
◆ Check panel intake grille - it must not be closed.
◆ -> With false measurement of temperature sensor -A-:
- With operating and display units -E87 with two displays, check blower -V42 -D- and associated intake
hose -B- (=>Page 184 ).
- With operating and display units -E87 with one display, check blower -V42 (=>Page 184 ). The tem‐
perature sensor is permanently installed into -E87.
Audi A3 1997 ➤
Heating, Air Conditioner - Edition 06.2000
6.12 - Removing and installing dash panel temperature sensor -G56 183
To Next Page
Loading...
