Audi A3 1997 - 1.14 - Removing, installing and adjusting Bowden cables from;on the heater control

Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
Colour: Yellow (grey).
- Bowden cable -C- for temperature flap.
Colour: Brown (white).
1.13 - Connection diagram for Bowden cables on the heater control
Notes:
◆ When assembling, secure the Bowden cables with cable ties and clips so that they cannot come into contact
with moving parts.
◆ Colours in brackets apply to right-hand drive vehicles.
- -> Bowden cable -A- to footwell/defrost flap.
Colour: Green (black).
- Bowden cable -B- to central flap.
Colour: Yellow (grey).
- Bowden cable -C- for temperature flap.
Colour: Brown (white).
1.14 - Removing, installing and adjusting Bowden cables from/on the heater control
Remove Bowden cables
- Remove footwell vent =>Page 112
- -> Lever off securing clip -A-.
Audi A3 1997 ➤
Heating, Air Conditioner - Edition 06.2000
1.12 - Connection diagram for Bowden cables to the heater control 105