EasyManua.ls Logo

Audi A3 1997 - Coding of Operating and Display Unit with One Display

Audi A3 1997
241 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
a vehicle without map-controlled cooling (for
indices "M" and "N")
3 = Audi A3
1 = Compressor without sender for speed
4 = 4-cyl. Engine
0 = petrol engine in an LHD vehicle
(e.g. 13140):
1 = Vehicle with map-controlled cooling (only for
indices "M" and "N")
3 = Audi A3
1 = Compressor without sender for speed
4 = 4-cyl. Engine
0 = petrol engine in an LHD vehicle
- Encode operating and display unit -E87 according to the vehicle type, engine and country.
- Press Q to confirm entry.
- Perform basic setting =>Page 24 .
Notes:
If an invalid code is entered in operating and display unit -E87, it is suppressed and the code "04042" (Audi
A4 4 cyl. USA) is stored. It could happen that the fault "sender for venting temperature in centre -G191" is
stored although this component is not installed into the Audi A3 without map-controlled engine cooling.
Assignment of operating and display unit
-E87.
=> Parts List
8.3 - Coding of operating and display unit with one display
Notes:
The operating and display units with the part number 9L0 820 043 and the indices "H", "J", "K" and "L" and
as of "O" are equipped with one display.
In vehicles with map-controlled cooling the coding of the operating and display unit -E87 is different than
vehicles without map-controlled cooling.
The main differences between the codes for "Rest of world" and "USA" or "Japan" are as follows:
USA = Temperature display in °F has priority over °C.
Japan = The function "Manually actuated
air circulation" is not erased
when ignition is switched off.
- Connect fault reader V.A.G 1551,
Enter address word 08 "Electronic climate/heating control" and advance the program until "Select function
XX" appears on display => Page 4 onwards.
- Switch on printer by pressing PRINT key (lamp in key lights up).
-> Indicated on display (function selection):
Audi A3 1997
Heating, Air Conditioner - Edition 06.2000
8.2 - Coding of operating and display unit with two displays 29

Table of Contents

Other manuals for Audi A3 1997

Related product manuals