Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
◆ When inserting bolts -D- into holes, ensure that bolts do no come into contact with the airbag unit bracket.
11.2 - Removing and installing the air conditioner heat exchanger
- -> Remove air conditioner => Page 206 .
- Press back catches -B- and remove the heat exchanger -A- from the heater.
Notes:
◆ Secure the installed heat exchanger in the heater flap unit using 2 suitable screws -C- (e.g. 3.2 x 20 mm
self-tapping screws).
◆ The heat exchanger is installed in the heater flap unit without an all-round seal (vehicles without map-
controlled cooling).
◆ The refrigerant hoses are to be connected on the correct side. Different connection and flow direction of the
refrigerant dependent on the type of heat exchanger => Page 117 .
◆ -> Replace gasket -A- and check for correct positioning on contact surface -C-.
Audi A3 1997 ➤
Heating, Air Conditioner - Edition 06.2000
212 87 - Air conditioning
To Next Page
Loading...
