EasyManua.ls Logo

Audi A3 1997 - Page 78

Audi A3 1997
241 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
-> Pin assignment for air conditioner pressure switch -F129
Switch between contact 1 and 2 (opens in the event of vacuum and overpressure in the refrigerant circuit - the
compressor is switched off)
Switch between contacts 3 and 4 (closes if pressure increases in the refrigerant circuit - the radiator fan is
switched to 2nd speed)
Pin assignment at refrigerant temperature switch -F18 / -F54
Switch -F54 (between contact 1 and 2 closes at approx. 95 °C - the radiator fans are switched to 1st speed).
Switch -F18 (between contact 3 and 2 closes at approx. 102 °C - the radiator fans are switched to 2nd speed).
Refrigerant temperature control switch (too hot) -F14
Switch opens at approx. 118 °C - the compressor is switched off.
Note:
Only installed in vehicles with pressure switch -F129
=> Current Flow Diagrams, Electrical Fault-Finding and Fitting Locations
Test step 1 (voltage supply)
Select measuring range on hand-held multimeter V.A.G 1526:
Voltage measurement (20V =)
Test step Contact at
connector to
-J293
Testing of ▪ Test conditions
- Additional opera‐
tions
Specified value Remedies if specified
value not attained
1.1 Connector B
contact 3
and
connector A,
contact 6
Voltage supply - approx. battery volt‐
age
- Use current flow dia‐
gram to repair power
supply and/or earth
connection.
1.2 Connector B
contact 4
and
connector A,
contact 6
Voltage supply - approx. battery volt‐
age
- Use current flow dia‐
gram to repair power
supply.
Select measuring range on hand-held multimeter V.A.G 1526:
Voltage measurement (20V =)
Test step Contact at
connector to
-J293
Testing of ▪ Test conditions
- Additional opera‐
tions
Specified value Remedies if specified
value not attained
1.3 Connector A
contact 4
and
connector A,
contact 6
Voltage supply - approx. battery volt‐
age
- Use current flow dia‐
gram to repair power
supply.
1.4 Connector A
contact 9
and
connector A,
contact 6
Voltage supply ▪ Ignition on. - approx. battery volt‐
age
- Use current flow dia‐
gram to repair power
supply.
Audi A3 1997
Heating, Air Conditioner - Edition 06.2000
72 01 - Self-diagnosis, Electrical check

Table of Contents

Other manuals for Audi A3 1997

Related product manuals