Audio Technica System 20 PRO - How to Pair Devices

44
How to pair devices
In this user manual, making a receiver and transmitter register each other is referred to as a “pairing”.
1
Set the receiver to pairing mode.
Refer to "Pairing mode" (p. 62) for details.
“Pairing” appears on the display of the receiver.
2
With the transmitter off, press and hold (approximately 5 seconds) the power button.
3
When the indicator lamp of the transmitter flashes alternately between green and red, release this
button.
“Pairing” appears on the display of the transmitter.
4
When pairing is complete, a completion screen appears on the display of the receiver.
The indicator lamp on the transmitter stops flashing and remains lit.
If the transmitter firmware is old, a message prompting you to update it will appear on the receiver. If this
message appears, refer to "How to update the firmware" (p. 75) and update the firmware.