Setting ATW-R1440
52
Alphabetic characters (uppercase letters), numbers, symbols (_, +, −, #, &, period), spaces
The number of characters that can be entered is 8.
1
From the receiver settings menu, select “NAME” and press the control dial.
2
Turn the control dial, select the desired character, and then press the control dial.
The character is input, and the cursor moves.
3
Repeat the operation in step 2 to enter all characters.
4
Select “End” and press the control dial.
The setting is complete.
Setting the reception mode
The default setting is “Standard”.
“Standard” is a low-latency mode.
In “HD Mode”, lowering the transmission rate of the audio to narrow the occupied bandwidth of the radio wave
enables simultaneous operation on multiple channels more than when “Standard” is selected.
“Standard” allows for reception on two channels. “HD mode” allows for reception on four channels.
Changing the reception mode deletes the pairing information.
When receivers are RX linked, changing this setting on the base unit changes the setting on the expansion unit to
match.
When receivers are RX linked, the expansion unit cannot be set. The current mode is displayed.
1
From the receiver settings menu, select “RF MODE” and press the control dial.
2
Turn the control dial to select “Standard” / “HD mode” and press the control dial.
3
Select “OK” and press the control dial.
The setting is complete.
Setting the lock
Set this function to prevent the receiver settings from being changed.
The default setting is “Off”.
To Next Page
Loading...
