Audio Technica System 20 PRO - Notes on Use; This System

4
Notes on use
This system
Be sure to read the user manual for any microphone or cable that you attach to the product.
If you use the product near a TV or radio antenna, noise may be generated in the TV or radio. If this occurs, move the
product away from the device.
Be careful of interference noise caused by the surrounding radio wave environment and similar factors.
This system may be affected by the spark noise of vehicles, dimmer of lighting apparatus, computers, office
automation apparatus and electronic musical instruments. Place and use the product where it is less likely to be
affected by the above.
Be sure to use this system in combination with components specified by Audio-Technica.
When installing this system, ensure that–wherever possible–there are no obstacles between the receiver unit and
transmitter. If the antennas are hidden with this product rack-mounted, install the receiver unit externally.
Over time, discoloration may occur due to ultraviolet rays (especially direct sunlight) and friction.
It is legally prohibited to dismantle and modify this product. In addition, this product is so precisely manufactured
that dismantling it could cause electric shock, failure, or fire. Never dismantle this product.
When multiple units are used simultaneously, transmitters should be at least 1m (3.3') apart, and transmitters and
receivers should be at least 2m (6.6') apart. Receivers that are not linked should be at least 1m (3.3') apart.
When a howling, beeping or squealing sound is produced during use, turn down the output volume of the connected
mixer/amplifier.
Receiver
Be sure the connected cable is plugged all the way into the product.
Transmitter
When used together with a guitar, the transmitter may easily be affected by magnetic noise depending on the type of
pickup. If noise occurs, install the transmitter at least 30cm (12") away from the guitar pickup.
If you use the transmitter close to an electronic or communications device (such as a mobile phone), the transmitter
may produce unwanted noise. If this occurs, move the transmitter away from the device.
To prevent depletion of the rechargeable batteries, turn off the transmitter when not in use and when not loaded in
the charging station.