Setting ATW-R1440
54
Setting the level meter display
Switch the AF status on the main screen to the “Pre” meter (the received audio signal level) or “Post” meter (the output
level of the receiver).
The default setting is “Pre”.
Changing this setting changes the mark in the AF status part.
1
From the receiver settings menu, select “UTILITIES” and press the control dial.
2
Turn the control dial to select “AF METER” and press the control dial.
3
Turn the control dial to select “Pre”/“Post” and press the control dial.
The setting is complete.
Setting multipairing
You can pair multiple transmitters to a single channel. This function allows you to immediately switch to a different
transmitter when the battery of the one in use dies or when you want to change the type of transmitter.
The default setting is “Off”.
Select “On” to pair up to four transmitters to a single channel.
1
From the receiver settings menu, select “UTILITIES” and press the control dial.
2
Turn the control dial to select “MULTI TX” and press the control dial.
3
Turn the control dial to select “On”/“Off” and press the control dial.
The setting is complete.
Setting the control dial
You can invert the direction of the operation performed when the control dial is turned.
The default setting is “Default”.
To Next Page
Loading...
