Audio Technica System 20 PRO - Unlocking the Receiver

Setting ATW-R1440
53
Setting this to “On” makes operation impossible. To change the settings, unlock the receiver.
1
From the receiver settings menu, select “UTILITIES” and press the control dial.
2
Turn the control dial to select “AUTO LOCK” and press the control dial.
3
Select “On”/“Off” and press the control dial.
The setting is complete.
Unlocking the receiver
To operate a locked receiver, unlock it.
The receiver will be locked again if no operations occur for approximately 10 seconds.
1
With the receiver locked, press and hold (approximately 2 seconds) the control dial.
2
Turn the control dial to select “Yes” and press the control dial.
The receiver is unlocked.
Setting the mix output
You can output mixed audio from the AF balanced output connector 4/MIX.
The default setting is “Discrete”. The audio of the transmitter connected to channel 4 is output.
Select “Mix” to output a mix of the audio from the transmitters connected to channels 1 to 4.
You can use the dedicated software (Wireless Manager) to configure more detailed settings.
1
From the receiver settings menu, select “UTILITIES” and press the control dial.
2
Turn the control dial to select “OUTPUT MIX” and press the control dial.
3
Turn the control dial to select “Discrete”/“Mix” and press the control dial.
4
If you selected “Mix”, turn the control dial to select “Line”/“Mic” and press the control dial.
The setting is complete.