Setting ATW-R1440
51
Receiver settings menu list
Receiver settings menu Details
DEVICE ID Set the device ID.
NAME Set the name.
RF MODE Set the reception mode.
UTILITIES
AUTO LOCK Set this function to prevent the settings from being changed.
OUTPUT MIX Set whether to mix and output audio.
AF METER
Switch the level meter on the main screen to the meter of the receiver
or transmitter.
MULTI TX
You can use this setting to register up to four transmitters to each
receiver channel.
CTRL DIAL Change the rotation direction of the control dial.
PRESET Save the settings. Or load saved settings.
RESET Set the receiver to the factory defaults.
VERSION Display the version of the receiver.
WEB MANUAL Display a 2D code for the manual.
NETWORK
IP SETTING
[1]
Set the IP.
REMOTE CTRL
[1]
Set the remote control.
SYSLOG
[1]
Set whether to send the log message to the Syslog server.
DISCOVERY
[1]
Set automatic detection by the software.
NTP
[1]
Set the NTP (Network Time Protocol).
MAC ADDRESS Display the MAC address.
[1] When receivers are RX linked, the expansion unit receiver cannot be set.
Setting the device ID
1
From the receiver settings menu, select “DEVICE ID” and press the control dial.
2
Turn the control dial to select the number, and then press the control dial.
It can be set from 0 to 999.
The setting is complete.
Setting the name
Set the receiver’s name. The following characters can be entered:
To Next Page
Loading...
